• Name

    Product family information

    Low-pressure mercury discharge lamp with a tubular 26mm envelope


    Longer lifetime and less early failures lead to less hassle and lower maintenance costs and facilitate the change from spot to group replacement
    Less waste and disposal cost at end-of-life
    Special fluorescent coating gives good colour rendering


    Significant reduction of early failures based upon a new technology (patent pending)
    Extra long and reliable lifetime
    Highly efficient 3-band fluorescent coating in combination with New Generation pre-coating technology
    Low mercury dose for a long-life lamp
    Fully recyclable lamp technology
    End-cap has an x-shaped green bottom plate to distinguish the lamp from other fluorescent lamps


    Suitable for use in applications where maintenance costs are high (high ceilings, difficult to reach): department stores, supermarkets, warehouses, production halls, offices and public areas like car parks and railway stations

    Warning & Safety

    To achieve published lifetimes for 100% operation, do not dim below 30%
    When used on electromagnetic gear, it is strongly recommended to apply only Philips S10 or S10E starters (for 18W types S2 or S2E) to achieve the published lifetimes, and to install new starters when relamping.
    A lamp breaking is extremely unlikely to have any impact on your health. If a lamp breaks, ventilate the room for 30 minutes and remove the parts, preferably with gloves. Put them in a sealed plastic bag and take it to your local waste facilities for recycling. Do not use a vacuum cleaner.
    • Add product
    • Add product
    • Add product
    Add product